These steps describe how to get started with ChirpStack Gateway OS after you have installed ChirpStack Gateway OS on your gateway.
Important: The chirpstack-gateway-os-full image will setup the PostgreSQL on its first boot. This could take a couple of minutes and during this time, the gateway will be less responsive!
After booting the gateway, you need to login using SSH. In case the gateway running the ChirpStack Gateway OS supports WIFI, then it will be configured as access-point with the name
ChirpStackAP and password
ChirpStackAP. Once connected with
ChirpStackAP the IP of the gateway is
If you are connected using ethernet, then it uses DHCP to obtain an IP address. Many internet routers provide a web-interface with the IP addresses of connected devices.
If the IP of your gateway is
The default username is
admin, the default password is
This will prompt the following message:
________ _ _____ __ __ _ / ____/ /_ (_)________ / ___// /_____ ______/ /__ (_)___ / / / __ \/ / ___/ __ \\__ \/ __/ __ `/ ___/ //_/ / / __ \ / /___/ / / / / / / /_/ /__/ / /_/ /_/ / /__/ ,< _ / / /_/ / \____/_/ /_/_/_/ / .___/____/\__/\__,_/\___/_/|_(_)_/\____/ /_/ Documentation and copyright information: > www.chirpstack.io Commands: > sudo gateway-config - configure the gateway > sudo monit status - display service monitor
Then execute the
sudo gateway-config to configure the channel-configuration that the gateway must use.
Unlike the chirpstack-gateway-os-base image, you should not update the ChirpStack Gateway Bridge configuration. It is configured to point to the MQTT broker which comes with the chirpstack-gateway-os-full image.
When using the chirpstack-gateway-os-full image, proceed with the following guide to get started with ChirpStack Application Server after you have configured the channel-plan.
Important to know
SD Card wearout
Although ChirpStack Network Server and ChirpStack Application Server will try to minimize the number of database writes, there will be regular writes to the SD Card (PostgreSQL and Redis snapshots). According to Is it true that a SD/MMC Card does wear levelling with its own controller? it might make a difference which SD Card brand you use.